...
| COLOR | Description |
|---|---|
| SOLID BLUE | Good telemetry signal being received by the Transmitter from the receiver. Will flash GREEN with each telemetry packet lost. |
| SOLID GREEN | Transmitter operating normally with valid PPM input, but NO telemetry being received. ( normal indication if receiver is turned OFF ) |
| SOLID RED | No PPM signal being received by the Dragon Link Transmitter. Check RC transmitter settings, trainer port / DSC settings, and connections to RC transmitter. |
| FLASHING WHITE | Hardware error codes, contact us through email support for assistance |
| FLASHING YELLOW | User configurable Alarms, Combined with tone, to alert you if certain parameters are exceeded. Battery Alarm, RSSI Alarm, etc. etc. |
Buzzing/Beeping Error Code Indicators
If the transmitter beeps on power up (without holding any buttons) then its an error code that will repeat after a certain interval. The following describes the errors:
# of Buzzes/Beeps | Description |
|---|---|
| 1 | Not used |
| 2 | Problem validating saved settings. Default settings loaded and saved. Power-cycle the receiver and bind again. Settings from GUI will also be reset. This is normal to see after a rmware update |
| 3 | Problem initialising memory for data logger |
| 4 | Problem with the RF hardware |
| 5 | Overvoltage detected (feature not enabled yet) |