Page Comparison

Kevin Li

Daniel Puratich (Unlicensed)

• Hot air station sourcing

• Testing Firmware

• Block Diagram

Kiran Surendran

Jason Skells

• Got the motor controller ready for design review

• Fixing issues brought up in the design review

Muhammad Tanveer

• Finished temp sensing, finalized sourcing (other than headers)

• Finalize header sourcing

• Clean up schematic for design review

Darwin Clark

• Soldered 90% of components on FWTraining (ADC, Headers, ect.)

• Got through ~10 more pages in Buck Converter Datasheet

• Solder remaining components on FWTraining

  • Start to verify board? Reach out to Gordon?

• Finish Buck converter datasheet

• Create + Check-in new Altium project

• Source components for buck converter

• Finish schematic

Seungmin Hong

• Select viable batter connector

• Schematic design review

Ethan Abraham

• Created spreadsheet and gone through LM25116 formulas with example design given

• Tweak independent variables to minimize ripple voltage, power losses, etc.

• Choose values based on part availability

• Finish schematic and sourcing for next Monday

Jatin Mehta

• Started checking out DigiKey gate drivers

• Read through more datasheets

• Create spreadsheet with possible components for motor controller

Kevin Song

Neel Bullywon