Phoenix updated on grabCAD so that all sides of the body are the same length and there are slots instead of holes for the wires. Julian Yam
Mounting holes on the base are not accurate. We need to fit three boards in the body of Phoenix.
1st board: IMU
from requirements: This board needs to be mounted unidirectionally. There will be a mounting bracket for the IMU, there needs to be mounting holes for this bracket. This board needs to be mounted in the center of the drone.
2nd board: Nucleo 32,64,or 144
These mounting holes can be found on their respective spec sheets
Nucleo needs spacers from the base plate as this board has pins that stick out from the bottom.
3rd Board: Motor controller
Mounting pattern can also be found on spec sheet
Preferably this board is mounted in the center so that all wires are equal length.
Mounting holes need to be updated to fit the boards
How is this going to be done? Since some of the boards need to be mounted in the center of the drone, can the board still be mounted on the bottom plate? Do the boards need to be stacked? Do the boards need to mounted vertically?