...
Optical flow sensor on drones allow centimeter level precision when hovering in place, since the system is capable of determining very small movement vectors. This allows the drone to hover in place, or track the ground in a very straight line in autonomous or guided flight modes.
Warg commonly uses the following 2 sensors:
Name/Link | Use case |
|---|---|
Competition Drone OFS | |
Firmware testing & Test drones |
Constraints & Mounting Requirements
| Note |
|---|
Please refer to manufacturer documentation for sensor-specific orientation. Links to product pages are in the table above. It is also recommended to always use an optical flow in conjunction with a rangefinder, this is so that differences caused by changes in altitude can be better accounted for |
General mounting requirements are listed below:
Unobstructed FOV | Since the OFS generates movement vectors based on differences between scans, it’s important that stationary objects like landing gear or wires. |
|---|---|
Cable/Connector Access | It’s important to be able to probe signal wires and test the device, so cable/connector access is important |
Minimum height | Please refer to the manufacturer specification for minimum height that the optical flow will work, and ensure that the optical flow is always above that height when resting on the ground. This ensures that the OFS will continue to give good data all the way until landing. |
Parallel to the ground, facing downwards | This should be pretty self explanatory. When the drone is level, the OFS should also be level and facing towards the ground. |
In general, it can also be desirable to have tho OFS centered at the center of rotation of the aircraft, so that any rotation (yaw) can be rendered as pure rotation. If this is not possible, offsets for the optical flow sensor can also be added but they must be known to centimeter level.
When pairing the optical flow with a rangefinder, it may be desirable to mount them close to each other (so data is more similar), but this is not a hard requirement.