Status: Active

Owner: Zen, Taim

Requirements

• Passthrough 18 V - 55 V (6S lower voltage to 12S upper voltage )

• Measure current through hall effect current sensing (without a shunt resistor to minimize losses)

• Measures voltage with an ADC

• I2C or UART interface

  • Preference toward I2C, but just pick one of them

• XT90 connector for input power and output power

• Maximum current passthrough requirements

  • Max pulsed current 200 A

  • Max continuous current 150 A

• Steps down input voltage to clean 5V and 12V rails

• Refer to Nathan’s current power module, photos in discord, for a reference to what this board will be replacing.

...