...
Based on dimensions Arjun provided, the servo gearbox container was modified (updated dimensions) to fit the new aluminium bend mounts.
There are ambiguous dimensions in the manufacturer’s dimensions; the figure below shows uses “(GUESSGUESSED)” to indicate the unknown dimensions which can be changed later.
...
Due to the slight changes in dimensions, the mount is made slightly wider (from 35 mm to 40 mm wide) to adapt the increase of horizonal distance between left and right (AKA the 1.061 inch). Below is how the sub-assembly look like now.
Side note: The countersink holes position on the baseplate are constrained to the aluminium bend mounts.
...
Drawing of the plate with countersink holes and DXF of the new bend mounts are created, located under:
C:\WARG_CAD\COMP2024\Antenna Tracker\Yaw-And-Pitch Antenna Tracker\Drawings and DXFs
Files are called:
ANTENNA_TRACKER_SERVO_MOUNT_01_BASEPLATE.SLDDRW
ANTENNA_TRACKER_SERVO_MOUNT_01_BASEPLATE.PDF
Flat pattern - ANTENNA_TRACKER_SERVO_MOUNT_03_STAND_EDIT.DXF
Only one DXF was created because the mirror of the mount is the same as bending the plat layout to the opposite side.
replaced the old ones mounts in main assembly with the new ones:
...