...
- Drawing uses the WARG drawing template.
- If the part is to be made on a mill ordinate dimensioning is used, with limited exceptions for pitched dimensions of holes, or to use proper GD&T for locating geometry.
- Drawing has millimeters as the primary dimension and inches as the secondary dimension. (Note that this is part of the WARG drawing template!). The exception to this is datums, these should have only one dimension (since both are 0). Secondary dimensions in inches are not required.
- Greater precision than 0.00mm & 0.000in dimensions is never used.
- Wherever reasonable, circular dimensions are given as a diameter, not a radius.
- All circular parts and features have center marks & center lines.
- All hole callouts are made with the hole-callout feature, and the generated callout is not modified except with valid reasons. To do this, your model must use hole wizard!
...