...
All corners have been printed and placed in the case. The monitor fits snug in the case with the corners and prevent rotation.
The spacers are waiting to be printed. (how deep should the M3 holes be?
The top plate has been updated and is waiting to be laser cut buy the RPC
Author: Smile Khatri Date: 2024/09/26
Design review (moving over from the old ‘Monitor Mount’ doc
Make a prototype using particle board at RPC - Callum
The top plate is 18.42” x 13.47”, can’t be water jet in E5. Can be laser cut at RPC, or water jet in E3 EMS.
Material selection up to Callum. Acrylic or aluminum.
Spacer should be a separate part. Maybe 3D printed, and use a heat set to fasten to top plate.
make out of hole wizard and use normal screw clearance.
...
Make holes with hole wizard. Holes should be normal screw clearance.
Idea: could cut out a groove in the corner piece that the bezel slides so that a top plate is not necessary
