...
Powered by a 3S (12V) battery input.
In the context of integrating with the ELRS board, an XT60 connector should be provided, and additional PWM input from a header pin should be placed (unsure of this requirement given we want to use DSHOT).
3x solder pads for BLDC connection.
Supports DSHOT input.
More resistant to noise in transmission versus PWM, as DSHOT is a digital protocol.
Must use the AM32 open-source firmware for motor control. (https://am32.ca)
This uses a sinusoidal algorithm to control the BLDC. (no FOC)
Has a strict MCU compatibility list (we would preferably use a smaller ST chip)
Designed around an target motor (in Houston): https://innov8tivedesigns.com/cobra-cm-2217-20-brushless-motor-kv-950.html
Standard 3-phase brushless DC motor with 12 stator windings and 14 exterior magnet poles, meaning 4 coil windings per phase. Designed for 3S/4S power source.
With a higher density of magnet poles in the rotor, smoother torque is able to be produced by the motor. The rotor being on the outside gives more torque as well.
Maximum continuous current of 20 Amps.
Should be accounted for during FET selection.
...