...
Author: Jack Doehler Date: 2024/11/07
...
V1.0
Notes:
Assembly consists of separate top and bottom case pieces.
There should be enough room for the Seeeduino, which was not included in the STEP file I used for reference.
Overall footprint of case is 80mm x 80mm x 30mm.
...
I’m a little concerned with the clearance of the red section in the image below with the board so I might suggest shortening/cutting the section to line up with the mount height/thickness (if that makes any sense)
...
Author: Jack Doehler Date: 2024/11/21
V1.1
Notes:
Addressed all the previous issues regarding minor adjustments (removing unnecessary stand-offs, adjusting certain dimensions to make printing easier).
I measured the board in-person and increased the height of the top case which should now fit the Seeeduino.
I increased the height of the bottom case so that there is a clearance of at least 10mm for any screws that are sticking out below the board. I believe this should be enough from what I could tell by looking under the board, though wasn’t able to measure directly.
I increased the spacing slightly between the board and the case walls to allow for any components to have some more clearance horizontally.
Overall footprint of case is 80mm x 80mm x 40mm.
