...
Anti-tipping bars finished and fully integrated into motor mount with cavity for cables.
The manufacturing of the main pieces of the landing gear is done, only the cf members left.
Drawings for the cf members will be done soon, need to rethink pump mounts as well. I also need to adjust the dimensions where the 3D printed part meets the aluminum bracket (0.4 mm) since it was a tight fit.
Added depth limiters due to vague bucket dimensions, they reach out until the OD (22”). This helps meet the clearance with the scoop servo, which is currently around 90 mm.
There’s a 1mm gap between the end of each landing gear hole and the tube, as advised by Conall Kingshott.
The angle of the gear is still 20 deg.
...