...
Because of the waterjet availability changes are any of your previous edits still things that you want changed?
If nothing is fastened to the holes behind the ones I added then yes I will remove them, main is checked out at the moment but once I gain access to it I’ll remove those holes if possible (if not I’ll move the new ones a bit further away)
The space between the two holes is exactly 60mm so yes the old P007 will fit (I double checked in SolidWorks) however it will be very tight. The only change in P007was increasing the space so that the batteries would fit easier
Author: Evan Janakievski Date:
Because of the waterjet availability changes are any of your previous edits still things that you want changed?
No changes to be made apart from carbon fiber plate and necessary boxtube adjustments
If nothing is fastened to the holes behind the ones I added then yes I will remove them, main is checked out at the moment but once I gain access to it I’ll remove those holes if possible (if not I’ll move the new ones a bit further away)
The space between the two holes is exactly 60mm so yes the old P007 will fit (I double checked in SolidWorks) however it will be very tight. The only change in P007was increasing the space so that the batteries would fit easier
Change the distance of the holes to be the center distance from C24_JIG_P007
I used inches to make these parts as boxtube is in inches (foolish of me in the long run), so it might be an awkward millimeter measurement for center of the holes
These old ones have a slight bit more clearance for the battery and would allow us to use the old jig to build this new one