...
The updated holes look good, but maybe we remove the holes that are right next to them?
The close distance is 1.44 mm which might get broken off in the waterjet
Also need to keep in mind width of batteries, which are 58 mm about
The current width is 59, so maybe we use the old P007 as there is limited waterjet availability
The old one has an inner width of 60 which is what the space between the peek standoffs are and is already known to be enough clearance for the batteries
Do you remember what dimensions were changed on P007 between the first revision and this version?
Author: Shawn Henry Dragon Date:
Because of the waterjet availability changes are any of your previous edits still things that you want changed?
If nothing is fastened to the holes behind the ones I added then yes I will remove them, main is checked out at the moment but once I gain access to it I’ll remove those holes if possible (if not I’ll move the new ones a bit further away)
The space between the two holes is exactly 60mm so yes the old P007 will fit (I double checked in SolidWorks) however it will be very tight. The only change in P007was increasing the space so that the batteries would fit easier