...
TELEM_PT1 & TELEM_PT2
telemetry passthrough connectors
connect this board between two devices by connecting TELEM_PT1 & TELEM_PT2 to different boards using a 1:1 6pin JST-GH harness
CAN/I2C_PT1 & CAN/I2C_PT2
CAN/I2C passthrough connectors
connect this board between two devices by connecting CAN/I2C_PT1 & CAN/I2C_PT2 to different boards using a 1:1 4pin JST-GH harness
DEBUG
DEBUG connector, connects to a board’s 6pin JST-GH debug connector with a 1:1 harness, following WARG’s standard STM32 Programming Connector Standard
STLINK_V2
Connects to an STLINK_V2 with header cables
Connect the DEBUG connector to the board you’re debugging, then plug the header cables for the STLINK into the connector with a 1:1 pairing
Pins are not labelled, but pin 1 (top right) is NRST, follow the pinout on the STLINK accordingly
...
STLINK_V3 mini (we don’t have one yet but once we get one it will be super awesome)
Connects to an STLINK_V3 mini with the given cable
Connect the DEBUG connector to the board you’re debugging, then connect the STLINK cable to the STLINK_V3 mini
Use the key on the board’s connector to determine connector direction
...