...

STATUS: Wing Mounting Issues?

• New plate was water jetted, may need to cheat the holes a bit to make it fit, but will be fixed within next week

STATUS: Landing Gear

• Both are ready

• Rear landing gear might undergo one change, but usable for the time being and has servo mounted

STATUS: Overall Airframe Integration

• Need to mount electronics when ready. Does EE want this before harnessing?

• Waiting on EE harnessing to finish the wings

Avionics/EE updates

• STATUS: Harnessing (EE)

• STATUS: 6s Servo Module / Single Servo Module (EE / EFS)

• STATUS: Electronics Validation

  • Pixhawk:

    • Has been flashed with Arduplane firmware

  • Servo validation?

  • Sensor validation

    • Both M9N GPS have been tested over DroneCAN

    • Manasva Katyal Will test compass, rangefinder, ep dual, esc, motor next week

    • Can also test pitot tube once tubing is cut and mounted

• Thoughts on Nucleo breakout for ZP?

  • motor power and signal breakouts

  • built in sensors

  • signal connectors like zp dev interface

  • buck built in to power everything

• bringup priority?

...