Attendance

General Updates

Electronic component inventory status:
- found a lot of items
  - pixhawk 6x + power module, can gps x2, esc, motor, pitot tube tubing, ep dual
- recieved ordered replacements
  - compass, rangefinder

...

Both are ready
Rear landing gear might undergo one change, but usable for the time being and has servo mounted
- servo will be connected to the tail servo module

STATUS: Overall Airframe Integration

Need to mount electronics when ready. Does EE want this before harnessing?
- yes please
- sticky tape the ssd on top of servo motor on the wing
Waiting on EE harnessing to finish the wings

STATUS: Harnessing (EE)
- Jerry will lead eclipse harness work sessions
- EE will work on comp critical projects first and then focus on eclipse harness
STATUS: 6s Servo Module / Single Servo Module (EE / EFS)
- EFS
  - Was able to run off DroneCAN commands from Pixhawk!
  - Dynamic node and neopixel LED are almost done
  - Will be tested this coming week
- EE
  - Need one 6S servo module (needs to finish being validated)
  - Two SSD (one works, other probably does according to Derek Tang will be tested)
  - need Xt60 breakouts, Jerry will order on amazon
STATUS: Electronics Validation
- Pixhawk:
  - Has been flashed with Arduplane firmware
- Servo validation?
  - Will be tested in the coming week
  - test with SSD
- Sensor validation
  - Both M9N GPS have been tested over DroneCAN
  - Manasva Katyal Will test compass, rangefinder, ep dual, esc, motor next week
  - Can also test pitot tube once tubing is cut and mounted
Thoughts on Nucleo breakout for ZP?
- motor power and signal breakouts
- built in sensors
- signal connectors like zp dev interface
- buck built in to power everything
- Tracking antenna V1 from 2023 and zp3 interface board already has a lot of the components from the above
bringup priority?

STATUS: RPC Laser Cutting Jerry Tian
- Side Note: What are we planning to put on this plane?
  - Pixhawk, ESC+Motor, Servos, EP Dual
  - Anything else?
    - nope