STATUS: Harnessing (EE)
- Jerry will lead eclipse harness work sessions
- EE will work on comp critical projects first and then focus on eclipse harness
STATUS: 6s Servo Module / Single Servo Module (EE / EFS)
- EFS
  Was able to run off DroneCAN commands
  from Pixhawk!
- Dynamic node and neopixel LED are almost done
- Will be tested this coming week
- Two SSD (one works, other probably does according to Derek Tang will be tested)
- need Xt60 breakouts, Jerry will order on amazon
STATUS: Electronics Validation
- Pixhawk:
  - Has been flashed with Arduplane firmware
- Servo validation
  - Will be tested in the coming week
  - test with SSD
  ?
- Sensor validation
  - Both M9N GPS have been tested over DroneCAN
  - Manasva Katyal Will test compass, rangefinder, ep dual, esc, motor next week
  - Can also test pitot tube once tubing is cut and mounted
Thoughts on Nucleo breakout for ZP?
- motor power and signal breakouts
- built in sensors
- signal connectors like zp dev interface
- buck built in to power everythingTracking antenna V1 from 2023 and zp3 interface board already has a lot of the components from the above
bringup priority?

Pilot Training - Foam Plane

STATUS: RPC Laser Cutting Jerry Tian
- Side Note: What are we planning to put on this plane?
  - Pixhawk, ESC+Motor, Servos, EP Dual
  - Anything else?
    nope

Timeline???