...
Finally, to ensure there was space for the holes to be placed 28 mm apart according to the mounting constraint on Houston, the entire mount was lengthened to 40 mm.
Design #3 - 2024/02/9 - Author: Agapa Goombs
...
After meeting with Smile Khatri before 3D printing the part, a few small changes were made. These include increasing the base thickness by 2.5 mm to increase material at the bottom of the counterbore to 2.85 mm. The distance between the holes was also decreased from 28 mm to 24.5 mm to bring it in line with the mounting frame on Houston. Both of these changes ensured the part was compatible with the M3 screws used in mounting.
Design #4 - 2024/02/13 - Author: Agapa Goombs
Based on feedback from Smile Khatri after 3D printing the part, a few small changes to the 3D model were made. These include revising the bottom cut of the mount for weight saving. The mass of design #3 was 3.09 grams while design #4’s weight was decreased to 2.36 grams due to the revision.