Page Comparison

Engineer: Meghan Dang, PM Daniel Puratich EFS input Anthony Luo

Purpose:

• has a jst-gh 6pin to connect to board connectors, breaks out to diff types of stlink compatible to eliminate custom harness needs during efs validation

• should have every/most connectors necessary for efs

• just make firmware debugging a lot easier

Requirements:

• debugging connectors

  • st link v3 connector (link pls)

    • https://www.digikey.ca/en/products/detail/samtec-inc/FTSH-105-01-L-DV-K-TR/2649981

  • st link v2

• has clips for oscope

  • https://www.digikey.ca/en/products/detail/keystone-electronics/5010/255332

• button for NRST

  • TS02-66-70-BK-160-LCR-D

• tvs (close to button)

  • DESD5V0U1BA-7

• passthroughs for testpoints

colours:

6 pin telem / uart should be:
tx-orange / rx-yellow / rts-green / cts-brown / red / black

timeline:

• grind out saturday night 4 hour footprint speedrun challenge (gone wrong) no sleep no food just ball

• guys i kind of lied bc there were too many things to think about . will hopefully finish today !!!! (sunday)