...
Not sure if it came with a case or not…confirmation will be made soon (did not come with the case)
Constraints
Constraints | Written By | Append Date |
|---|---|---|
USB Port must be accessible | Oct 31, 2024 | |
Mounting holes must obey the 30.5 x 30.5 mm grid pattern | Oct 31, 2024 | |
Must fit on the tracking antenna base, without interfering with any other mounts | Oct 31, 2024 |
...
Mount Design Progress
Rough draft of CAD model has been drafted though I am having difficulties saving the files to PDM and am unsure how to get my design reviewed.
Sohee Yoon Date: 2024/11/21
Design Review:
Overall amazing job on the mount! I like how it replicated the case the website sells and the bottom stand offs are a great idea. I just had a few suggestions on the design:
It would be nice to have 30.5 x 30.5 mm M3 mounting holes on the other side too, just to secure the mount to the plate. Because of this change, we won’t need the slot/hole and pin on that side
I’m a bit concerned the cutout for the connection might be too small because the original case CAD had these dimensions 10.15 mm x 3.75 mm (I think your height was slightly below that), so maybe changing the dimensions so that we have enough clearance would be great (like below)
...
The cutouts on the top part is really nice, maybe we could add them on the bottom part too
Pins to align the board is a smart idea! But you’ll need some tolerance for them (right now the hole on the board and pin are the same size, but when you 3D print it won’t fit properly). The sizes on the original case CAD is 1.3 mm in diameter for the pin (red section below) and the hole on the top mount is 1.4 mm in diameter. We can try these dimensions out first and print to see how it fits
...
Task Progression/Updates
Jievan Tapajna Date: 2024/11/24
Mount Design Progress
Updates have been addressed aside from adding a second pair of M3 holes as the length of the board is approx 31.5mm which is longer than the 30.5x30.5 grid and would require the mount to be much larger.