✅ Important discussion topics

• Gemini

• Tracking antenna spec

• Software testing & Status

📝 Meeting minutes

...

Table of Contents

📝 Meeting minutes & decision log

< to be filled out during the meeting >

...

📡 Tracking Antenna Updates

Mechanical

Item	Notes
Introduction Arjun Mandair	Topics of Discussions Current Design Questions Link to Meeting Notes: 30/05/2023 Antenna Tracker Notes Link to Prior Constraints: Tracking Antenna Requirements
Current Design Photos & Videos Arjun Mandair	Picture of the Current Design For Patch Antenna Tracker ***NOTE*** current Antenna Tracker is designed only for Patch Antenna. Currently not compatible with Yagi Antennas. Potential Changes Move the battery and receiver mounting positions from their current positions to the side panels. Pros: Less material needed. More space for other electrical components. Cons: Not balanced around center of mass. Any thoughts? Previous Design of Antenna Tracker for Yagi Antennas As per discussion with Nathan Green, previous CAD and design has been lost Video of old Antenna Tracker for the Yagi Antennas: https://www.facebook.com/UWaterlooWARG/videos/tracking-antenna-first-testa-little-jumpy-but-a-great-first-test-signal-reliabil/661647633941945 Note that the parts utilized to create the Yagi Antenna Tracker were obtained from ServoCity: https://www.servocity.com/
Questions Arjun Mandair	Am I essentially making two separate Antenna Trackers for the Yagi antennas and the Patch antenna? Or am I making one Antenna tracker compatible with both? Anthony Luo suggested a “crossbow” like configuration where there's a flat plate above the drive servo so that the antenna can be centered . Are you referring to a flat plate similar to the one below? Are the current servo positions ideal knowing new constraints? Image Removed Anthony Luo asked if the current antenna tracker is compatible with HS311 servos. Should the designs be compatible with HS311 servos? Are the current servo positions ideal knowing new constraints? (Considering HS311 Servos, Torque, Wiring, Yagi Antennas, etc.) Image Added
New Constraints / Conclusions / Rough Notes	going for 2-3 weeks for a prototype that can rotate

Software

Yuchen Lin to fill out

mavlink passthrough in progress

planning to port neo m8 and bmx 160 driver to f401, and develop the motor control algorithm

create an integration test code and ready for test flight

Electrical

@nolan haines or Hardy Yu to fill out

...

• Yuchen solders the perf board for integrating the Nucleo and all the peripheral connections.

...

📶 Gemini Updates

Electrical

Michael Botros

• Schematic phase

• Deadlines assigned in Asana

If mech needs to design anything/ provide anything, please get that to mech leads within 1~2 weeks

...

💻 Command Software Updates

Autonomy

IMACS:

• working with DART MAVLink library. working on getting data telemetry setup.

  • two parts: reading from serial (get data from drone → in actual flight test), also reading from TCP so you can read mavlink from mock mission planner. → test gui without testing on actual drone

• when GUI starts up → need to request data to listen to and then you’ll get that stream of messages.

  • need to test and confirm.

  • Xierumeng able to use mock missions & wireshark to read mavlink messages? → did not make a request to receive those messages.

    • Mission Planner itself is requesting certain information && that info is forwarded blindly to GUI.

QR Code → Auto Mission

• Possible to not work with MP?

  • MP uses python2.7 (old).

• At end of comp → script generates a file, and then you manually add the file into mission planner. (does not count as autonomy)

Embedded Flight Software