...
https://blogupvertercom.wordpress.com/2014/05/28/schematic-style-guide/
...
| Table of Contents | ||||||||||||
|---|---|---|---|---|---|---|---|---|---|---|---|---|
|
Simple Internal Rules of Thumb
Rules are given in order of priority.
Consistency
a single schematic should follow the same styling conventions
passives to power rails should be vertical
i.e. i2c pullups and decoupling capacitors
schematics should follow a logical left to right flow
input on the left, output on the right
higher electrical potential (voltage) rails should be vertical and other passives (i.e. shunt resistors) above lower voltage rails
signal passives should be horizontal.
higher potential on bottom, lower potential on bottom
schematics should follow a logical left to right flow as this is how humans are used to reading! \Show Parameters for components
it should be obvious which parameter corresponds to which component based on proximity.
minimize corners in schematic wires when possible
components should be placed in the schematic near components they will be near in the layout when sensible
notably, decoupling capacitors should be placed in the schem near the IC they’re decoupling rather than say off on a random sheet. See https://uwarg-docs.atlassian.net/wiki/spaces/EL/pages/2178154501/Decoupling+Capacitors?search_id=be08defc-9cba-48a6-9283-64e3f906590c&additional_analytics=queryHash---0f1c3fed2128d86a807147c6bab7604e287482b1998d87d9ba440968c2c77c3f for further detail.
minimize length in schematic wires when sensible
do not use excessive hierarchy
do not excessively nest schematic sheets
minimize intersecting schematic wires when sensible
Why We do this
Standard
makes reviews easier
improves human readability
preparation for industry
We don't want to nitpick
If you have a reason for doing something slightly different it’s fine
there are a lot of edge cases these simple guidelines don't cover so do what’s best and call it a day
as long as you did something for a reason then it’s chill
do not do styling randomly/arbitrarily
Learning
The best way to learn is to look at schematics and see what you think is reasonable. Check out past WARG designs and see how they style their schematics. Not everything we do is perfect, but a lot of it is decent and a great starting place!