...
This device was built to function in auto-run mode, meaning that the end user can simply connect the USB-C port to a source and have a power to a load connected through the XT30. The board uses the USB-PD (Power Delivery) protocol to arbitrate its voltage and current with the source device.
NOTE: There are multiple board variants that arbitrate different voltage values. Check the silkscreen at the back of the board to view which voltage has been configured (circled with a marker).
The 20V, 15V and 12V boards are configured with a minimum of 3A and maximum of 5A current. This means that your source (wall power adapter) needs to be able to deliver the voltage circled on the silkscreen and a minimum of 3A current. This information is likely visible in fine print on the adapter.
The 9V board is configured with a minimum of 2A, and a maximum of 5A current. This means as low as an 18W power adapter (commonly shipped with smartphones) can work with this board.
IMPORTANT: By default, all of the boards will draw 5V until PD arbitration is complete, due to dead battery mode. If your use case must avoid undervolting, connect the USB-C Sink device to the source, wait briefly, and then connect your device with the XT30.
...
LEDs
To summarize the LED notes in the schematic:
...
The TPS25730 can provide debug and diagnostic information through the interface.
NOTE: The arbitrated voltage of the device is NOT configurable over I2C.
...