...
The updated holes look good, but maybe we remove the holes that are right next to them?
The close distance is 1.44 mm which might get broken off in the waterjet
Also need to keep in mind width of batteries, which are 58 mm about
The current width is 59, so maybe we use the old P007 as there is limited waterjet availability
The old one has an inner width of 60 which is what the space between the peek standoffs are and is already known to be enough clearance for the batteries
Do you remember what dimensions were changed on P007 between the first revision and this version?
Author: Shawn Henry Dragon Date:
Because of the waterjet availability changes are any of your previous edits still things that you want changed?
If nothing is fastened to the holes behind the ones I added then yes I will remove them, main is checked out at the moment but once I gain access to it I’ll remove those holes if possible (if not I’ll move the new ones a bit further away)
The space between the two holes is exactly 60mm so yes the old P007 will fit (I double checked in SolidWorks) however it will be very tight. The only change in P007was increasing the space so that the batteries would fit easier
Author: Evan Janakievski Date:
Because of the waterjet availability changes are any of your previous edits still things that you want changed?
No changes to be made apart from carbon fiber plate and necessary boxtube adjustments
If nothing is fastened to the holes behind the ones I added then yes I will remove them, main is checked out at the moment but once I gain access to it I’ll remove those holes if possible (if not I’ll move the new ones a bit further away)
The space between the two holes is exactly 60mm so yes the old P007 will fit (I double checked in SolidWorks) however it will be very tight. The only change in P007was increasing the space so that the batteries would fit easier
Change the distance of the holes to be the center distance from C24_JIG_P007
I used inches to make these parts as boxtube is in inches (foolish of me in the long run), so it might be an awkward millimeter measurement for center of the holes
These old ones have a slight bit more clearance for the battery and would allow us to use the old jig to build this new one
Author: Shawn Henry Dragon Date:
Removed M3 Holes closest to the holes for the jig
Confirmed battery clearance
Increased width of jig holes
Moved the jig holes slightly closer together so center distance matched the old P007 center distance