Meeting times:
EE Meeting: Thursdays 8 PM EST E5 1006
Leads Meeting: Monday 8 PM EST E5 2004
Team Competition Aircraft Sync (AEAC): Monday 7 PM EST E7 4043 or E5 1006
Attendance:
In person | Online |
|---|---|
🔗 Quick Links:
🍍 Updates this week!
Announcements/General updates
Competition Participation Interest form: If you're interested in going to competition, please fill out the form below! Note: this does not guarantee a spot at competition.
see what other school’s electrical system is like 🤩
90% chance that food and hotel are covered
Flight test: 2024-03-23 Comp Sim #1
Director Nominations: If you think you or someone else would make a good exec Director, please fill out the following form: https://forms.office.com/r/FY51bnHZsj
Team Roster: https://forms.office.com/r/ka0MJHJQ9D . If you are an active member, fill this out (ty)
Active PCB Projects
Drone Harness (Neel)
High Current Power Module (Taim)
Battery Elimination Circuit (Ishman)
12S ESC (Mena)
No updates, busy again at work.
6S ESC (Rayyan, Mostafa)
Rayyan: Halfway done Gate Driver Schematic
Need some help with correcting footprint
LED Controller (Neel, Parker)
No new updates due to busy work week
PDB (Tom)
Tracking Antenna (Nolan, Hardy, Michael)
ZP3 Rework (Anthony, Ryan)
Jerry Tian will review before next EE meeting
Redundant Diversity ELRS , RF project
5V-24V Boost Board
Talked to previous project owner, board is supposed to be used as variable voltage power supply for field testing. Multiple outputs is fine instead of one variable one as long as it’s properly labelled.
New Projects
Project | Link | Description | Needs Assessment |
|---|---|---|---|
Houston harness schematic | Draw houston schematic from scratch. We want a schematic for all possible power + sensor harnesses so that we can quickly build/grab harness for flight test | Wiring is too messy as of Feb 13, 2024. Also sensor harness is gonna be different for different flight tests
| |
Pegasus harness schematic | https://warg.365.altium.com/designs/EE4130C4-749C-446F-8B89-B208A6919071 | reorganize into hierarchical structure (see 12S servo module example) Label length, color, wire gauge | the schematic as of now is a bit hard to read |
12S ESC | Mena needs help ;d | see confluence page | |
CAN Interface | project on hold rn | ||
ICM 42688 breakout | Could get fancy using CAN bus w/it later but for now just breaking out SPI, and maybe having an onboard voltage regulator or smth (better perf). | EFS is looking to move from bmx160's to ICM 42688's . These are used commonly on all sorts of drones and fc's (probaly the most popular drone IMU being sold new right now). They're about 2$ for a chip, can be pick/placed by JLCPCB, but the eval kits are 58$. | |
Smoke stopper | Analog design. Switch between different efuses (e.g. 1A, 2A, 3A) | The board limits current flowing through when we run the motor test. It protects downstream electronic devices. It also prevents drawing too much current from the batteries.
leads need to decide whether we want a MCU on the PCB |