Task 2 Hook/Loop Idea - Linear Extension + Release

Task 2 Hook/Loop Idea - Linear Extension + Release

Note: Everyone contributing to this doc should have already carefully read through CONOPS, found here: https://www.aerialevolution.ca/wp-content/uploads/2026/09/2027-AEAC-CONOPS-v1.0-2026-09-08.pdf

Specifically, make sure you are familiar with the task two description, and the mark breakdown.

See pages 23-26 of the CONOPS, under section 5.2.4

Big Project

Project

Project Manager

Big Project

Project

Project Manager

Valkyrie

Comp 2027

Jackson Barber

Jackson Barber I can try to write these in within the next week, if you can fill them out yourselves that would be great

Constraints

Written By

Append Date

Constraints

Written By

Append Date

 Weight

 Leo Zhao

 

Size Between Landing Gear 

 Leo Zhao

 

 

 

 

 

 

 

 

 

 

 

 

 

Task Description

Task 2 is split into 2 main mechanical tasks, tagging and sample collection.

Tagging: We will create a custom tracker that can either be attached to the prop animal using a hook and loop fastener, or dropped in a nearby box for less points.

Sample Collection: We will look for and attempt to pick up 3 different kinds of samples

image-20260916-133013.png

After picking these up we will drop them off in a designated location

Task Progression/Updates

Author: Leo Zhao Date: Sep 30, 2026

 

Motor Release Mechanism: Similar to last year’s release mechanism of motor pulling a pin that holds the tracker. Since the tracker will be designed by us, we could use gears and just add a notch to the tracker that the pin can use to lock in in place Purely Mechanical Release Might fall off early but could be more reliable? Make a one time release mechanism that is activated by being pushed?
Linear Actuator to be used most likely? What length do we want it to extend? If really long we might not want an actuator since it can’t extend that much compared to its original height Potential Option? Boomstick like balloon that extends from CO2 tank?

November 10, 2026 Design Review Notes

  • Make servo wire hole bigger (~8mmx8mm)

  • Add screws for securing tracker together with the board inside

  • Proper mate for rod end ball joint (need to make sure that the rod won’t be poking out horizontally further than the tracker velcro