2023-06-26 AEAC2024<unnamed> Aircraft Sync Minutes

Meeting overview

Meeting to discuss state of Competition Aircraft big quad.

Motors/props arrived
Timeline review → things to flight test when.

Open action items

@EE to look at connectors for motor 3-phase

@Mech to send EE basic X-frame layout so that EE can come up with wiring diagrams/channels.

@Anni to look at static fire testing

Look at mounting the landing gear outside the x-frame w/adjustable angle?

@Conall Kingshott look at talking to bryan about composites

Meeting minutes

Item	Notes	Asana Links

Item	Notes	Asana Links
Finalized list of sensors	2024 System Architecture
Flight recaps	Vanny is our only test drone right now, so we don’t want to do too many risky things with it. However it flies very well
EE	Gemini progress? not much timelines for PCB phases on asana testing timeline interfering with exams?
Mech	CAD lookin crispy Base X frame. everything runs through the center cube of aluminum, largely hollow there is a 30x30 mm grid of mounting holes on the top pixhawk on the standoff’d plate above Batteries sit between the pale grey standoffs. Taking arms off for transport? CF tubes are screwed into these. Need 3 bolts to remove the arm need to thread cables through each time? if bullet connectors on the end of the tubes, through the block, at the end of each arm. just stick the arm on and plug it in Get someone from EE to slot on arms that connect with pins like a VGA port? no wires hanging out that need to be taped, etc Landing gear should also be considered - connectors for these Landing gear currently is a T shape, the X is not complete. the joint in grey above is 3D print, it is a shear point The X style landing gear may attach outside the main plate. This would be effective because wouldn’t need to take the landing gear off all the time. X frame itself is close to completion. To send to EE for sizing, placements. reduce noise keep signal integrity this is so mech can accommodate electrical wiring pre-finalization of the model Thinking about static testing? Drop testing? Simulators? not yet..? Not much interest/action on this Timeline Sourcing items: composites canada for CF bolts, peek, etc from mcmaster-carr resin and CF manufacture materials - has Brian (Engineering machine shop, previous SDC machine shop) set up an easy rental/pay per use for this? conall broke his finger so that will affect manufacturing timelines Push for maiden pre august