Page Comparison

Daniel/F0

• [ ] Update SWD/SWO

• [ ] UART Connectors are inconsistent with ZP1.0

• [ ] Add I2C/SPI select resistors for Safety IMU connector

• [ ] Update Schematic sheets with WARG templates

  • [ ] Update parameters (name etc.)
    

Test Points

• [ ] ENSURE footprint makes sense

• [ ] Vout of Temp Sensor

• [ ] All of SD pins SDMMMC1_XXX

• [ ] SWD/SWO connector
  

[ ] Overall

• [ ] Add ESD and overvoltage protection?

• [ ] Where should we add testpoints?

• [ ] Fix Duplicate Net Names Wires

• [ ] Add notes to decoupling caps → keep as close as possible

• [ ] Add NO ERC to NC pins

• [ ] Add calculations for schematic to google sheet

• [ ] Make all schematic symbol colours the same
  

[ ] H7PartA

• [ ] Confirm/clarify correct SWD/SWO pins are broken out to connector

  • [ ] Follow comment

  • [ ] Add SWO

• [ ] Rename SWO/SWD to H7 speccific

• [ ] Rename NRST to H7 specific

• [ ] Change NRST to a port since its off page?

• [ ] Remove pull up resistor for NRST

• [] Add sensor transfer function to temp sensors
  

[ ] H7PartB

• [ ] Do we want PDR_ON (power supply supervisor) pulled up all the time?

  • [ ] What are our options?

  • SOLUTION: DNP for one of the resistors to GND and keep 3V3 (follow schematic)

• [ ] How to clean up BOOT0 resistor situation?

  • [ ] Make sure its clear to only populate one resistor
    

[ ] H7Power

• [ ] What are we going to do with the DSI pins (VDD12DSI, VCAPDSI, VSSDSI**)**

  • [ ] It seems irrelevant to what we're doing, can we just ground it or leave it NC?

• [ ] What is the plan with internal SMPS (and the internal LDO for that matter)

  • [ ] Pins VDDSMPS, VFBSMPS, VLXSMPS, VSSSMPS

  • [ ] Research available configurations

  • [ ] Do we want to just ignore it and use the typical application LDO?
    

• [ ] LDO

  • Try a different package?

  • [ ] Add power ON LED here?

  • [ ] Add testpoints?

  • [ ] Add ESD & overvoltage protection

  • [ ] Check ESR for caps of LDO
    

• [ ] VDD USB

  • [ ] Allow for optional 5V USB Supply

  • [ ] Use 0Ohm resistors instead of solder bridges
    

[ ] microSD Schematic

• [ ] Update uSD connector footprint and symbol to be a bit cleaner

• [ ] Add uSD Detect and connect with microcontroller?

• [ ] Check if pull up resistor and capacitor values make sense