...
| Roadmap Planner | ||||||||||||
|---|---|---|---|---|---|---|---|---|---|---|---|---|
|
Open Questions
Do we want this to be a nucleo shield? I know this was mentioned throughout the meeting, but I don't remember if we came to a conclusion.
As it currently stands, when we refer to the “HIL controller,” we’re talking about the nucleo + the computer it interacts with. For the first revisions, we’ll design on a f401. In the future, this might turn into a nucleo shield, but we’re more likely to have a central controller (refer to below).
"Analog ↔︎ Digital conversion up to 6s VBatt" How do we want to do the analog to digital conversion? Where is the analog input coming from ?
We want to measure the analog voltage from our power distribution board. When the HIL reads this value, it then sends a signal to ZP indicating that our board is receiving a certain voltage. This voltage is “forwarded” to ZP which then determines which flight mode we’re in.
By "remote flashing" do we mean having the ability to flash when the programmer is not in physical contact with the device? Would the HIL then be under the view of a camera?
Due to the fact that the HIL controller is the nucleo AND the computer, we should be able to SSH into the system.
Will this ever interface with the simulator? I feel like this is more of a future expansion thing, especially because the simulator hasn't been started.
Yes, this should easily interface with the simulator because we are using a nucleo.
"Central controller raspberry pi" I'm not familiar with the pi, so how would this change the flow? Would the nucleo interact with the pi, which then interacts with ZP?
Long term scope for this project is to have one central controller, such as the raspberry pi, and several peripherals (decided to be nucleos as of now) that route through said central controller. For example, one nucleo might be dedicated to mocking an IMU, and another might be dedicated to mocking GPS. The use of a central controller would allow us to break the project up into smaller parts, and have dedicated modules for certain things.
Do I need to write a UART driver? Or can I use the HAL UART driver?
HAL UART driver is fine for now. If we have issues with the HAL UART, this will likely be a bigger issue.
I2C issues, and working with hardware that doesn’t exist. More direction on this would be nice.
✅ Actions Items
- Jack Greenwood create architecture diagram, documentation, & open questions!
...