IOC Configuration
...
USART2
Basic Parameters
...
Don’t touch Advanced Parameters
...
DMA Configuration
...
NVIC Settings
...
...
Getting Code Running
Add these lines of your code to main.cpp.
...
| Code Block | ||
|---|---|---|
| ||
/* USER CODE BEGIN 2 */
SBus sbus_data;
RCControl control_data;
/* USER CODE END 2 */
/* Infinite loop */
/* USER CODE BEGIN WHILE */
while (1)
{
/* USER CODE END WHILE */
sbus_data = sbus_pointer->GetSBUS();
control_data = sbus_pointer->GetRCControl();
/* USER CODE BEGIN 3 */
} |
Building and Flashing
Build using CMAKE with the appropriate command. Building inside STM32CubeIDE will give errors.
When flashing, go to debug configurations and change the C/C++ Application to point to ZeroPilot.elf
Also, select the “Disable auto build” option.
...
Troubleshooting
If all the values do not change and have a value of 1000 even when you move the controller, your ioc is probably not configured correctly. Otherwise, unplug and replug the tracer.
To Do
- Configure Nucleo pins
- Test data with a logic analyzer and RC controller
- Debug with interrupts
- Transmit receive signal to nucleo to check if the data is similar
...