Item | Presenter | Notes |
|---|
Intro | Conall Kingshott | |
Flight tesstests | Conall Kingshott | We attempted a hover test this weekend. We flipped the drone, but the problem has been diagnosed. Not damage on the mechanical front. More info can be found here:
2023-10-14: Pegasus Hover, ZP3.5 M1, & Pilot Trainning There will be a flight test this weekend, trying hover again. More info is here:
https://uwarg-docs.atlassian.net/l/cp/xguRBjuH |
Shared Spaces Meeting | Conall Kingshott | https://uwarg-docs.atlassian.net/l/cp/RqH5y2Xu |
Electronics Cases | Nathan Green | LTE Case VTX / Antenna Case
|
Frame | Conall Kingshott | No major updates |
Antenna Tracker | Arjun Mandair | This is going on a bit of a break for the moment because Arjun is busy and we don’t have other people to support it atm. If anyone has a concern with that, please contact me directly. |
Cabin
| Alison Thompson
| Cabin design still underway! Evan Janakievski has been working hard on the Skeleton ! Georgia Vachon Westerlund Updates to CAD and some CFD simulation results: https://uwarg-docs.atlassian.net/l/cp/qrpZo69M Following the feedback from last week’s meeting, I made the front/rear panels 2 mm thick and the side panels 4 mm thick Added a 50 mm (length tentative) to the top and bottom of the front/rear panels. This segment will be bent up into the cabin when it is assembled Chose a bend angle of 20 degrees, this angle is tentative pending simulation results. The part files in PDM have been updated in accordance with the design changes shown below:
 Georgia Vachon Westerlund Ran a couple of preliminary aero CFD simulations Took me a while to download and learn the software Created a “control block” with similar dimensions to the cabin to be used as a basis for CFD analysis (CAD available in PDM as well):  Used Ansys fluent to setup meshing, boundary conditions, simulation domain, etc. Results are as follows: For future simulations, would like to determine the effect of the 20 degree bend angle on the lift/drag coefficients New model has already been made, just need to run that simulation later this week and compare results to the control block:  Would like to evaluate the relationship between the bend angle and the lift/drag coefficients Would like to evaluate how effective s-ducts would be (a bit more advanced, I’ll need to get more familiar with Ansys Fluent first).
Sohee Yoon has taken on the Aero-Panel mounting and it’s looking great! Want to explain your ideas? Aero-Panel Mounting ? Jason Li want to share your seat updates? I see some nice sketches in Seats ! Wallace Lee are you still interested in doing Cargo Compartment ?
|
| | |