Big Project | Project | Project Manager |
|---|---|---|
Electronic Mounts | RPI 5 Case |
Task Description
Design and 3D print a mount for the RPI 5 to secure it on Pegasus 2.0.
Constraints
Constraints | Written By | Append Date |
|---|---|---|
Ports must be accessible (will update with specific ports later) | July 24, 2024 | |
Mounting holes must obey the 30 x 30mm grid pattern | July 24, 2024 | |
RPI 5 will replace the phone that is on Pegasus 1, so it will likely go where the phone is currently | July 24, 2024 |
Relevant Contacts
To be written by the component owner and should be used if collaborating with another subteam. This should be the “component owner” of the other subteam and/or the person on those subteams. Delete if not used. DELETE THESE INSTRUCTIONS BEFORE PUBLISHING
Subteam | Contact | Contact Description |
|---|---|---|
Tech dir |
| |
Autonomy Lead |
|
Assignees
Assignee | Asana Task | Date |
|---|---|---|
@Calum Chisholm | link to asana task assigned | Date assigned |
Task Progression/Updates
Calum: @ person updating Date: 2024/07/30
Created Case
2 Mounting holes that are 58mm apart 💀
Top Case has connections that will mount to the PI and will go through bottom half of case to mount onto drone frame
All Ports are accessible
