Motor and propellers have arrived. Motor mount to be adjusted accordingly.
Manufacturing started last week. The progress so far:
- All plates for the frame have been waterjet
- Finished few stand-offs for the frame + 1 wing-spar
Plan for this weekend:
- Waterjet the landing gear and a motor mount
- Finish the second wing spar and tail boom (should be achievable this Saturday)
Empennage design complete, balsa sheets, and wooden dowels need to be procured (that’ll happen this week)
- using 2 servos for the elevator, 1 servo for the rudder. They have been ordered alreadyarrived.
Wing manufacturing timelines
- Could we get started on 1 of the wings this weekend since the spar is done? - Smile
- Nathaniel:
  - Been busy with some school stuff recently but the only thing blocking wings are the ailerons
  - We could manufacture some ribs and 3d prints for the spacers but assembling should be held off
  - Will order more balsa

Avionics

...

6S Servo module
- coming in sometime this week, assembly not until next term unless otherwise requested
- aiming for bringup + validation early next term
Redundant 5v buck?
- ordered and will be assembled and validated by EE co-ops this term.
single servo driver
- firmware stuff?
do we want LED controller Rev 4 on this?
more details on wiring the airframe
- do we have all the components needed?
- Jerry Tian for interest in creating harness diagrams
- is there a diagram for this + locations on the airframe?

Timeline