...

• Motor and propellers have arrived. Motor mount to be adjusted accordingly.

• Manufacturing started last week. The progress so far:

  • All plates for the frame have been waterjet

  • Finished few stand-offs for the frame + 1 wing-spar

• Plan for this weekend:

  • Waterjet the landing gear and a motor mount

  • Finish the second wing spar and tail boom (should be achievable this Saturday)

• Empennage design complete, balsa sheets, and wooden dowels need to be procured (that’ll happen this week)

  • using 2 servos for the elevator, 1 servo for the rudder. They have been ordered already.

• Nathaniel Li Wing manufacturing timelines?

  • Can Could we get started on 1 of the wings this weekend since the spar is done? - Smile

  • Nathaniel:

    • Been busy with some school stuff recently but the only thing blocking wings are the ailerons

    • We could manufacture some ribs and 3d prints for the spacers but assembling should be held off

Avionics

• What is readiness of all of the following boards!

...

• When is servo module rev 2 coming in?6S Servo module

  • coming in sometime this week, assembly not until next term unless otherwise requested

  • aiming for bringup + validation early next term

• Redundant 5v buck?

• single servo driver

  • firmware stuff?

...