Versions Compared

Key

  • This line was added.
  • This line was removed.
  • Formatting was changed.

Agenda

Table of Contents
minLevel1
maxLevel6
minLevel1
outlinefalse
stylenone
typelist
printabletrue

...

General Updates

Flight Tests

...

  • Use LCSC components on new boards (Ideally from the JLC library) for PnP

  • TURN OFF DMMs WHEN DONE please!

  • Don’t forget to fill out the team roster: https://forms.office.com/r/ka0MJHJQ9D

  • Make sure to clean up after yourself

  • Get the electronsite role if on site - reach out to Ryan Scomazzon if you have issues

  • Competition syncs Mondays at 9pm

  • Eclipse sync Tuesdays at 8pm

  • Tracking antenna meetings

    • Sunday 2pm

  • Reach out if you need help on a project or bootcamp

  • Recruit your friends!

    • More fun with friends

    • If you like the team, then we can do even more with more people!

  • BEWARE OF SCAMS ⚠️⚠️⚠️⚠️⚠️

...

  • Board is unblocked now after midterms pog

  • Figured out how to do BEMF sensing

  • Planning to jam pack the STSPIN with optional sensing since it has many op amps built in

  • Can do FOC with shunt resistors, but too expensive for this ESC (question) thoughts?

    • Should give it a shot if the added complexity doesn’t push design to 6 layers

Tracking Antenna Controller + ELRS Gemini Tx Ahmed OsmanNolan Haines

  • we need to solder the tx modules that game recently on the gemini tx board and test asap

  • once done we can get started on the architecture

  • Ishman Mann can get involved

ELRS Gemini Xrossband TX Ishman Mann

  • architecture defined. Schematic in progress

  • 2 different frequencies (hence “Xrossband”)

    • lower frequency for better range

    • higher frequency for better throughput

  • ground-side transmitter

  • Jeremy Poulin interested in schematic & component selection

12V Input to 65W USB-PD Source - Electrical - WARG Ian Van Den Steen

  • Need to figure out current sense.

  • Andrew Chai to help review low-side shunt configuration

  • Other than that need to change a couple things in schematic (change GPIO), do filter sim, then will go onto layout

...

  • Stalled until someone is able to drive it (Megan Lee interested after getting more experience)

Open Tasks

Action Items

  • test tx