...
Adjusted the span of the guard to cover 180 degrees. This way, the propellers would be protected when flying into corners.
Extended the length of the guard to make sure propellers are not vulnerable for drone tilting angles up to 45 degrees.
Added more material to the ends of the guard to make it more rigid and less bendy.
Author: Smile Khatri Date: 2024/11/23
I like the idea to taper the cantilever supports
The new prop guard is too large to be printed on our Bambu printer. The dimensions for the maximum print volume is 256 x 256 x 256 mm.
Is it possible to make the prop guard smaller? If not, is there an alternate material we could use? thinking of possible laser cutting this out of a stiffer material. This will get rid of the extruded regions but if the material is stiff enough that may not be needed
Author: Jonathan Zhao Date: 2024/11/23
Solution for print bed size: divide the guard in two (it can be attached the same way) The right half is shown here:
...
If this does not work, laser cutting using acrylic could work. However, it may cost up to 20$ for the material (unless we have some laying around). Acrylic may also be significantly heavier.
Info on laser cutting:
https://docs.google.com/forms/d/e/1FAIpQLSeQgt7yA1XXWc0RUd-lscotb2IVward67466BYuQT7E_EY_dw/viewform