Versions Compared

Old Version 5

changes.mady.by.user Kiran Surendran

Saved on

compared with

New Version Current

changes.mady.by.user Kiran Surendran

Saved on

Key

  • This line was added.
  • This line was removed.
  • Formatting was changed.

Not added to ASANA

  • Daniel/F0

    • [ ] Update SWD/SWO

    • [ ] UART Connectors are inconsistent with ZP1.0

    • [ ] Add I2C/SPI select resistors for Safety IMU connector

    • [ ] Update Schematic sheets with WARG templates

      • [ ] Update parameters (name etc.)

    Test Points

    • [ ] ENSURE footprint makes sense

    • [ ] Vout of Temp Sensor

    • [ ] All of SD pins SDMMMC1_XXX

    • [ ] SWD/SWO connector

  • [ ] Overall

    • [ ] Add ESD and overvoltage protection?

    • [ ] Where should we add testpoints?

    • [ ] Fix Duplicate Net Names Wires

    • [ ] Add notes to decoupling caps → keep as close as possible

    • [ ] Add NO ERC to NC pins

    • [ ] Add calculations for schematic to google sheet

  • [ ] H7PartA

    • [ ] Confirm/clarify correct SWD/SWO pins are broken out to connector

      • [ ] Follow comment

      • [ ] Add SWO

    • [ ] Rename SWO/SWD to H7 speccific

    • [ ] Rename NRST to H7 specific

    • [ ] Change NRST to a port since its off page?

    • [ ] Remove pull up resistor for NRST

  • [ ] H7PartB

    • [ ] Do we want PDR_ON (power supply supervisor) pulled up all the time?

      • [ ] What are our options?

    • [ ] How to clean up BOOT0 resistor situation?

      • [ ] Make sure its clear to only populate one resistor

  • [ ] H7Power

    • [ ] What are we going to do with the DSI pins (VDD12DSI, VCAPDSI, VSSDSI**)**

      • [ ] It seems irrelevant to what we're doing, can we just ground it or leave it NC?

    • [ ] What is the plan with internal SMPS (and the internal LDO for that matter)

      • [ ] Pins VDDSMPS, VFBSMPS, VLXSMPS, VSSSMPS

      • [ ] Research available configurations

      • [ ] Do we want to just ignore it and use the typical application LDO?

    • [ ] LDO

      • [ ] Add power ON LED here?

      • [ ] Add testpoints?

      • [ ] Add ESD & overvoltage protection

      • [ ] Check ESR for caps of LDO

    • [ ] Use only Murata/Kemet caps?

  • H7 PartA

    • [] Add sensor transfer function to temp sensors

  • H7 Power

    • [ ] VDD USB

      • [ ] Allow for optional 5V USB Supply

      • [ ] Use 0Ohm resistors instead of solder bridges

      • NOTE: Not doing this anymore?

  • [ ] microSD Schematic

    • [ ] Update uSD connector footprint and symbol to be a bit cleaner

    • [ ] Add uSD Detect and connect with microcontroller?

    • [ ] Check if pull up resistor and capacitor values make senseConfirm 10k pull ups are fine