Page Comparison

Kevin Li

Daniel Puratich (Unlicensed)

• Technical report review

• Sponsorship request for TEquipment

• Equipment sourcing document progress

• ZP2 documentation

Kiran Surendran

Jason Skells

• Finishing up the motor controller layout after revising the placement

• Finish the PCB layout

• Get a digikey order in

• Documenting the board

Muhammad Tanveer

• Finished most of the BMS schematic (including sourcing)

• FET selection

• Diode selection

• Finalize BMS circuit

Darwin Clark

• About halfway though with Buck converter whitepaper

• Finish buck converter whitepaper

• Do self breakdown/analysis of power distribution sch.

Seungmin Hong

• Sourced, created and implemented current sense resistor

• FET selection

• Diode selection

• Finalize BMS circuit

Ethan Abraham

• General buck converter topology and functionality

• CCM and DCM

• Component Sizing and Efficiency Losses

• Go through derivations again

• Go through PCB placement

Jatin Mehta

• Continued going through the BLDC motor section

• Work on research project - making notes on MOSFETs, Power MOSFETs

Kevin Song

Went through BLDC motor section

Power MOSFETS and MOSFETS research