Daniel/F0
[ ] Update SWD/SWO
[ ] UART Connectors are inconsistent with ZP1.0
[ ] Add I2C/SPI select resistors for Safety IMU connector
[ ] Update Schematic sheets with WARG templates
[ ] Update parameters (name etc.)
Test Points
[ ] ENSURE footprint makes sense
[ ] Vout of Temp Sensor
[ ] All of SD pins SDMMMC1_XXX
[ ] SWD/SWO connector
[ ] Overall
[ ] Add ESD and overvoltage protection?
[ ] Where should we add testpoints?
[ ] Fix Duplicate Net Names Wires
[ ] Add notes to decoupling caps → keep as close as possible
[ ] Add NO ERC to NC pins
[ ] Add calculations for schematic to google sheet
[ ] Make all schematic symbol colours the same
[ ] H7PartA
[ ] Confirm/clarify correct SWD/SWO pins are broken out to connector
[ ] Follow comment
[ ] Add SWO
[ ] Rename SWO/SWD to H7 speccific
[ ] Rename NRST to H7 specific
[ ] Change NRST to a port since its off page?
[ ] Remove pull up resistor for NRST
[ ] H7PartB
[ ] Do we want PDR_ON (power supply supervisor) pulled up all the time?
[ ] What are our options?
[ ] How to clean up BOOT0 resistor situation?
[ ] Make sure its clear to only populate one resistor
[ ] H7Power
[ ] What are we going to do with the DSI pins (VDD12DSI, VCAPDSI, VSSDSI**)**
[ ] It seems irrelevant to what we're doing, can we just ground it or leave it NC?
[ ] What is the plan with internal SMPS (and the internal LDO for that matter)
[ ] Pins VDDSMPS, VFBSMPS, VLXSMPS, VSSSMPS
[ ] Research available configurations
[ ] Do we want to just ignore it and use the typical application LDO?
[ ] LDO
[ ] Add power ON LED here?
[ ] Add testpoints?
[ ] Add ESD & overvoltage protection
[ ] Check ESR for caps of LDO
[ ] VDD USB
[ ] Allow for optional 5V USB Supply
[ ] Use 0Ohm resistors instead of solder bridges
[ ] microSD Schematic
[ ] Update uSD connector footprint and symbol to be a bit cleaner
[ ] Add uSD Detect and connect with microcontroller?
[ ] Check if pull up resistor and capacitor values make sense
Manage space
Manage content
Integrations