ZP3 Dev Interface Board

Every IO pin (~45) broken out

• Header: 2.54mm standard male pins (female?)

• Make sure to get 3v3

• Make sure to get 5v

  • multiple

• NOT VBat

• Pad beside header for oscope

Every IO pin (~45) broken out

• Header: 2.54mm standard male pins (female?)

• Make sure to get 3v3

• Make sure to get 5v

  • Multiple

• NOT VBat

• Pad beside header for oscope

• For PWM pins, break some (all?) out in a servo standard (signal power ground)

• Group UART with power, TX, RX, ground

• Very explitily labeled groups

• No power + gnd for SPI and I2C, just the data pins

• LEDS to unused GPIOs

Power and Interlock LED

Darwin Clark Will look into how possible this is

LEDs or indicator on all comm lines (Data lines of UARTs, I2C, SPI, PWM) ++

MicroSD card pins

MicroSD card pins break out

Pot, selectibly tied to analog input pin via header

Easily accessable ground (screwholes or on isolated male pin)

Easily accessable ground (screwholes or on isolated male pin)

In general making sure that things arn’t clumped together such that one is touching pads together