Skip to end of metadata
Go to start of metadata

You are viewing an old version of this page. View the current version.

Compare with Current View Page History

« Previous Version 2 Next »

Hi team! Please try an include as much detail as you can for the requirements.

Requirement

Subteam / Contact

Reason

eg: headers XG1 and EF2 must be easily accessible without un-mounting the case (not an actual req)

efs - Anni

These are used for programming & debug in critical scenarios

e.g. There must be active airflow from 40mm fans towards the Semtech transmitter modules, with at least 20mm clearance above the semtech modules

ee - Anni

Heatsinks will be placed on top of the semtech modules.

Active cooling must exist in order to maintain full-power output from the semtech modules.

e.g. There must be mounts for the SMA/RP-SMA side of a U.FL to SMA/RP-SMA adapter in the enclosure

ee - Anni

We will be using u.fl to SMA/RP-SMA pigtails, and we want securely mounted SMA/RP-SMA sides.

< link to pigtail >

e.g. The xt-30 power connector U_ must be exposed

e.g. There should be a solid top-face of the case

ee

Protection from top-down rain ingress.

 Notes:

Complete water-proofing is not the intention. The intent is to make it less likely for light rain/snow buildup to damage our system.

Board may be mounted “upside down” (i.e. hung from the top of the case).

Louvres may be used on sides / bottom of the case to help prevent water ingest while still allowing for airflow.

  • U2 and U6 (only the coax output in the top left corner, rest can be covered)

  • All connectors/pin headers (J1, J2, J3, J4, J5, J6, J7, P1, P2)

  • ESP32 reset button (S1)

  • Chip antennas on left/right edge of the board (AE1, AE2)

  • The big white status LED near the centre (D1)

EE- Farris

General ease of use.

  • No labels