Intro

This is the page for the ZeroPilot Validation image.

Processor: STM32L562ZET6Q.

Channel	Goal/Scope	Proposed Testing Strategy
SPI	Can transmit and receive data from and to a device. Can use chip select/enable line to selectively communicate with multiple peripherals.	Send sample SPI signals through the channels and verify output using Saleae Logic Analyzer.
UART	Can transmit and receive data from and to a device. Can communicate at different baud rates.	Send sample UART message through each channel and verify output by connecting to a terminal.
I2C	Can transmit and receive data from and to a device.	Saleae Testing
PWM	Configure the PWM signal generation	Basic: DMA:
GPIO	Can toggle on and off.
ADC	Varying analog input is converted to a digital binary output.	Connect potentiometer to ADC in channel. Vary voltage input. Output binary values to terminal?
MicroSD	Read/Write data to the SD Card.	Write: Create text file, write to the text file, plug the SD card into a computer and confirm that the test text file has been created and written to. Read: Read from a test file. Check size of variable to see that they match.
On-board LEDs	Can light up.	Run simple blink test code onto each LED.

I2C
- Make sure data can be sent and received using I2C channel by simulation/emulation of i2c peripheral
UARTs
GPIO
ADC
- Run a known input signal through the ADC, read the output data, does it match the expected?
SPI
PWM DMA
PWM Basic
- Test a simple PWM output to onboard LEDs is possible (assuming the LEDs work)
MicroSD Slot
- SDMMC?
Power LEDs
- Plug it in… does it explode? no? lights are on? should be good then.
Set the HSE - High Speed External Oscillator How to use HSE STM32CubeMx
- RCC → HSE → Crystal/Ceramic Resonator (figure out the desired frequency)
IO Connector Interlock

What is a buck converter? Do I have to test this?

Do I need to do input power validation/power source testing? - probably

A solid tutorial video with a simple custom PCB Bring-Up:

Create the stm32 project
message aidan bowers and ask if he has successfully flashed the zeropilot pcb with open ocd or if it would be easier to use the st link… and how to connect (i have never flashed to zp before!)
Breakdown all tasks on asana
Figure out how to test all inputs and outputs
User friendly?
Confluence document with clear instructions.

ZeroPilot Validation Image