Skip to end of metadata
Go to start of metadata

You are viewing an old version of this page. View the current version.

Compare with Current View Page History

« Previous Version 4 Next »

ST-LINK Wiring:

To flash to the board, the following pin arrangement is needed on the board:

The pins are arranged next to the chip and can be seen below marked in blue, purple, grey, and white:

Wire Colour

Pin Name on ST-LINK

Pin Name on Breakout Board

Blue

RST

NRST_PILOT

Purple

SWDIO

SWIO_PILOT

Grey

SWCLK

SCLK_PILOT

White

GND

GND

Green

3V3

3V3

Additionally, power is required for the board, either using the USB port on the board, or by connecting the 3v3 pin on the ST-LINK to the green pin seen above. The pin labels for that row of pins can be seen below, the 3V3 pin on the board and ST-LINK should match up.

The board should light up once it has power. Additionally, the ST-LINK will have a red light when powered and a blue flashing light when signals are being sent through it.

  • No labels

0 Comments

You are not logged in. Any changes you make will be marked as anonymous. You may want to Log In if you already have an account.