You are viewing an old version of this page. View the current version.
Compare with Current View Page History
« Previous Version 10 Next »
Member
Updates
Action Items
Kevin Li
Daniel Puratich (Unlicensed)
Hot air station sourcing
Testing Firmware
Block Diagram
Kiran Surendran
Jason Skells
Muhammad Tanveer
Finished temp sensing, finalized sourcing (other than headers)
Finalize header sourcing
Clean up schematic for design review
Darwin Clark
Soldered 90% of components on FWTraining (ADC, Headers, ect.)
Got through ~10 more pages in Buck Converter Datasheet
Solder remaining components on FWTraining
Start to verify board? Reach out to Gordon?
Finish Buck converter datasheet
Create + Check-in new Altium project
Source components for buck converter
Finish schematic
Seungmin Hong
Select viable batter connector
Schematic design review
Ethan Abraham
Created spreadsheet and gone through LM25116 formulas with example design given
Tweak independent variables to minimize ripple voltage, power losses, etc.
Choose values based on part availability
Finish schematic and sourcing for next Monday
Jatin Mehta
Started checking out DigiKey gate drivers
Read through more datasheets
Create spreadsheet with possible components for motor controller
Kevin Song
Neel Bullywon