What
add in CAN support
four pin JST for drone
use common CAN circuit referenced in ESC CAN Adapter with stm
change to support peggy and fixed wing mechanical packaging
need to validate the motor mount strategy works. Alternatively 30x30mm might be nice to mount on bottom of center frame?
fix all comments in schematic
firmware:
ardu support for thsi ensured.
controllable from controller on ground.
all components on one side of the pcba?
easier to paste them all in one go.
Concerns
must use low datarate and both CAN buses to avoid sublength becoming an issue
Why
we are able to control the pattern in firmware without reflashing the boards
Simple 1:1 harness can be used
Who
When
Manage space
Manage content
Integrations