Introduction
Who
Daniel Puratich Architecture Only
tbd
What
A usb-c PD sink where we can select the output voltage with resistors
dnp and fitted resistors, should be foolproof 0805s
intent for requesting 24V 65W when debugging https://uwarg-docs.atlassian.net/wiki/spaces/EL/pages/2701197313/RPi+Interface+Rev+C?atl_f=content-tree setup without the full drone
should support 12V and 5V as well for testing other boards
use a usb-C pd chip and the associated required FETs that are required for negotiation
ideally no microcrontroller
usb c input conn
XT30 output connector
dont worry about board area too much but it can be tiny
no buck converter
ideas
Engineering
tbd