Buck converter:
Load regulation
Load transient
Vout ripple
Set up: Oscilloscope AC coupled, 1GHz bandwidh
Over current protection
The video below is testing the over current protection feature of the buck chip only, the PCB only has the buck circuit assembled at this point. The e-fuse chips and pwm buffer are not populated at this point yet.
Efuses
Setup:
With 47 Omhs connected, For U4, U3, U2 Measured Vout on board to be roughly 5.95V, U5 was roughly 0V
Over Current Test. Used 8, 10Omh Resistors in parallel, R_L = 1.25Omh, Current Loaded (ideal) = 4.8A
With 1.25Omhs connected For U4, U3, U2 Measured with DMM Vout on board to be 1.9V and steady decline till 1.3V, U5 was roughly 0V
EFuse U5: (At 4.8A Unresponsive)
EFuse U4 (4.8A):
EFuse U3 (4.8A):
EFuse U2 (4.8A):
Short-to-ground Test
EFuse U5: (Taken on Different Day)
Efuse U4:
Efuse U3:
Efuse U2 :
