• Fasteners and everything have been redone and are working well.

• Landing gear is okay, but unideal atm. We will want to redesign at some point, but this is not top of the list.

• No notable damage from flipping is nice?

• Not too many updates because of reading week

• Skeleton dimensions have been updated and current updates can be found here: Skeleton

• Aero-panels are in the works and updates can be found here: Aero-Panels

• Aero-panel mounting is being worked on, updates in Aero-Panel Mounting soon!

• Going to be checking in on all these projects tomorrow at mech meeting

• Not much updates, still under R&D

Unchanged from lasting sync:
Still needs to be delegated out.

• Have a few people who are nearly done with bootcamp that could be assigned to this.

• What we have on drone right now is at least in the ballpark, but we do want to calculate eventually.

• Neel: Checked conops didn’t see any requirement for Passenger LED at least for scoring points, could still be something we add if we want

• Neel: No real updates, been really busy with work. Will try to do more this week.

Farris carried 😎, notes he left:

• Through hole components still need to be soldered on, we also didn’t get the SMD loop testpoints in the order so we’ll need to order those w the next Digikey order

• Quite a few bridges to clean up on some of the ICs

• ESP01F still needs to be ordered in the next aliexpress order and assembled. Some of the pads for it are bridged and will need to be fixed to prevent shorts

• One board is missing an 0603 green LED, 1 got lost while I was placing them

• Some of the pads for the TX modules may need to be touched up on 1 of the boards
  

Mechanically on pause until further notice.

• discover compiled BMX160 offical sensor fusion library → currently integrating the driver

• GPS driver test in progress

• verify the actual algorithm math working

• Anthony Luo doing presentations

• more people should get trained, we need pilots!