...
Board Name | status | blockers | plan going forward |
|---|---|---|---|
Tracking antenna | assembled SMT components on 2 boards |
| continue debugging and document process |
ESC CAN | Assembled SMT components on all 5 boards Resoldered some components that did not reflow well/had some minor issues (mainly the STM32) | EFS needs to do testing to confirm full validation of the board BM06 Connectors not in yet, need these to program the boards
| Validate EE side of things - testing for shorts, continuity, etc |
...
CAN DSHOT Controller
need to deliver to EFS to test the CAN circuit
will solder BM06 connectors on during friday sesh and validate LDO
when will this be ready
Tracking Ant Controller
need to deliver to EFS immediately
RPi Interface Rev B
need to deliver, ideally done this weekend so autonomy can test before next weekend
Daniel will participate in session for sure but would be nice if someone here to PM
Peggy 2 Lighting Board Rev 3
validate CAN circuit with CAN DSHOT Controller before assembling this
let’s assemble the bottom side this weekend?
other side need to wait for LCSC order
Daniel will participate in session for sure but would be nice if someone here to PM
Single Servo Module
for fixed wing, assemble before midterms
6S Servo Module
for fixed wing, assemble before midterms
12S Servo Module - Electrical - WARG (atlassian.net)
On hold to focus on comp critical Peggy 2 tasks.
Status update:
2nd board is not seeing any voltage on buck vout, while 1st board was fine.
would like to run battery inrush test at Vin, see Efuse and Battery Inrush test plan
most likely is my soldering skill issue, feel free to take a look if you’re interested
...