Controls:
Anni + ??
Attitude Manager ??
Specifications
Target 1: Stable flight in all directions
Target 2: Fancy flight in all directions
How are we localizing - how does PM know to tell us which way to go!?
do we operate under one local heading as 0 and PM handles the rest of the spinny localization?
local or global reference frame? → not high priority (but I think local is easier?)
matters for directional flight (left/right/up/down), but we dont really care about the ORIENTATION of the robot
see VRC 5225A global positioning system premilinary doc from 5225a, 5225a code release
Other Considerations:
How to handle pre-flight sensor calibration (is it triggered by user for tele-op or occurs automatically before flying?)
How to handle catastrophic failure - if the entire controller system fails to work, would we shut off all motors and let it fall? Or is there a defualt motor PWM value that can allow the drone to fall softly without damaging itself?
Timeline
development start by reading week.
Wednesday reading week → discuss how to approach this in terms of implementation
Manual controls with RAW PWM values can be done by E.O. reading week.
Implementing fancier methods later.
Meetings
October 7, 2021
Send E-mail to Stephen Smith Friday Oct 8th 2021 → end of day. (or early saturday).
come up with some ideas to send to him about controls
hopefully get guidance wrt our specific requirements → help us choose methods?!
Sending info to the drone as a spline (especially for autonomous flight)
→ see FRC 254 controls giving splines and not raw values (link to 254 presentation)
can fall back to raw pwm % difference if necessary
Focus on two aspects
teleop and autonomous. → both get pretty ok with vectors.
for autonomous → pm should give us a vector.
for tele-op, depending on how we handle it, calculate internally or in PM - also consider that PM is on Autopilot while Teleop and RC input will be on safety (prob best to keep teleop localized completely on safety)
PM → tell you where to go | AM → figure out how to get there without crashing
Definitely can get manual control done by end of reading week with raw pwm values.
fancier flight will have to come later.
October 5, 2021:
Start development by the end of reading week.
Meet next Thursday 7:30.
Come with ideas. Be prepared to prepare documents.
Questions and critical areas to ask the experts.
Reach out on friday.
Take weekend to look over data
Try to meet next tuesday.
Aim for reading week start
Try to make applicable for hexa/quadcopter (depending on what’s chosen). Worry about layout agnostic controls later
0 Comments